The Basic Instructions On Eye Washing Station

By Virginia Gibson


When a potentially dangerous chemical or even irritant enters ones eye, it is very important for them to clean it off or risk damaging their sight. Knowing how to effectively and properly flush the chemical out can really save someones sight. A big percentage of workplace injuries can actually be prevented by simply using the proper safety equipment. Eye washing station can save ones sight if properly installed and used by workers.

In case you are working and some significant amount of chemical or some irritant substance enters your sensitive organs such as an eye, knowing the proper procedure to effectively flush the chemical out can really save ones sight. Once that happens one is advised to immediately go to the companys eye wash rooms with any delay.

If a poisonous chemical splash in ones eye, then should be aware that time is actually of essence. Visit the station immediately which is only less than fifteen seconds walk away from you or your working area. Once you reach the emergency room, push the level installed there which activates the unit.

A recent research carried out by BLS showed that out of every five cases of injury that happen in working environments, more than three of the employees are injured because they wore the inappropriate gear or completely ignored to wear the safety gear at all. Following all the safety instructions in a work environment will definitely improve work efficiency.

Workers are advised to ensure that their hands are free and its not necessary for them to keep holding open the lever. Once the unit gets activated, the unit usually stays on. Make sure the eyes are wide open by simply holding their lids apart using your fingers. This is paramount to ensure that the fluid reaches all parts of that organ.

Every worker should be able to clearly locate their eye wash and the emergency shower. Emergency showers are required to be close enough just in case it is urgently needed. This equipment should be readily available within the shortest time possible from the place where hazardous or risky materials are being used.

The paths to the station are supposed to have not obstacles or any kind of obstructions. The time taken to reach such stations should not be more than ten seconds. All objects that might be on the paths which might block the efficiency of reaching the shower should be removed. The second instruction is using only the approved safety equipment.

In case the chemical is probably an acid considered corrosive, then the emergency should be more close and also urgent. When deluge or cornea wash stations are more need is in case the chemical that entered the cornea is considered toxic by MSDS. Also if the chemical is corrosive or caustic, then deluge shower is inevitable.

When MSDS indicates possible serious injuries on cornea or pupil, then use of eye wash will definitely be needed. All the containers with dangerous chemicals should be clearly labeled so that workers can exercise extra caution when dealing with them. All the deluge showers actually should contain, clean and pure water, ability to simply operate without using hands, constant flow of water for more than 15 minutes and unobstructed access.




About the Author:



No comments:

Post a Comment